Previous Article

How to Modify a Trailer Hitch

Next Article

How to Buy FEMA Trailers

How to Wire a Trailer Hitch Element

The Honda Element allows you to hook up a trailer and tow whatever you'd like with the trailer hitch component. Although you can tow whatever you'd like, you need to do so within legal limits. In order for the component your towing to be legal, you'll need to properly wire taillights to the trailer.


  1. Go under the driver's side of the vehicle just below the dashboard to find the harness plug for the wiring unit. If you are having trouble locating it, its the plug that is located near the inner corner of the dashboard. Depending on the particular vehicle model, it may have a blue piece of tape wrapped around it. Check the vehicle's manual if you are having any further difficulty.

  2. Attach one end of the trailer wiring harness to the harness plug and insert the fuses, that came with the kit, to the fuse panels on the wiring harness.

  3. Attach the module box from the wiring harness on the trailer to the firewall. The firewall should have a piece of two-sided tape on to make it easier to affix to the box.

  4. Open the rear door on the vehicle and open the spare-tire box. Look for the harness plug; it should be located near the rear bumper.

  5. Take off the cap on the harness plug. Plug the other side of the trailer wiring harness into the rear harness plug. Place any excess trailer wiring into the spare tire compartment and put it back into the floor panel until it is secure. Then close the rear door of the vehicle.