Previous Article

How to Change the Oil in a Nissan Maxima

Next Article

How to Replace the Headlights on a Nissan Maxima

How to Install Nissan Maxima Fog Lights

The fog lights installed on your Nissan Maxima need to be checked at least once every six months to a year to ensure that they are in proper working order. Overtime the fog light housing lens seal can give way and result in a build up of excess moisture inside the lens.

What You'll Need:



  • Assembly (if necessary)

  • Socket wrench

  • Socket set

  • Replacement fog light



  1. Locate the hood release latch inside the vehicle and engage it. Once engaged open the hood and locate the battery.

  2. Disconnect the negative battery cable by loosening the nut on the negative cable clamp. Once it is loose enough slide the cable off of the negative battery terminal.

  3. Locate the two nuts that are holding the fog light assembly in place and remove them. These nuts should be located on the rear side of the fog light housing.

  4. Move the housing forward and disconnect the electrical connector from the rear of the fog light ballast.

  5. Gently move the fog light assembly all the way out and install the new assembly, if necessary. If the assembly does not need to be replaced, push in on the fog light and turn it in a counterclockwise direction until it unlocks from the housing. Ensure that you don't turn it with too much force to ensure you don't cause any unnecessary damage to the unit.

  6. Insert the new fog light and begin reassembling the unit by performing the steps backwards.

  7. Reconnect the battery cables and turn your vehicle back on to ensure that the light is working correctly.