Previous Article

How to Remove a Nissan Xterra Door Panel

Next Article

How to Replace a Nissan Xterra Radiator

How to Replace a Nissan Xterra Knock Sensor

Replacing a Nissan Xterra knock sensor is not a difficult job if the SUV owner is handy with a wrench. When the knock sensor goes bad, it is important to replace it in order to identify potential problems with the vehicle’s engine. The best place to find a replacement for the sensor is at a local Nissan dealership.


  1. Go to the parts department of a local Nissan dealership to purchase a new knock sensor for your Xterra. Inform the clerk of the year of your Xterra to see if the sensor is in stock. Order the sensor if it is not currently in stock and find out when it will be available for you to pick up.

  2. Park your Xterra in a well-lit area once you pick up the new knock sensor. Get an adjustable wrench from your toolbox and raise the hood on the SUV. Find the knock sensor behind the intake manifold and loosen the bolt holding it in place.

  3. Inspect the old sensor before you remove it. Check the electrical wiring to make sure that it is not loose. If the wiring is loose, you may be able to secure it instead of replacing the knock sensor.

  4. Unplug the electrical wiring from the old knock sensor if you determine that the device needs replacing. Remove the old sensor after you unplug the wiring and compare the device with the new one to make sure that you have a proper match. Plug the electrical wiring into the new knock sensor and bolt it back into place. Close the hood and put away your wrench.

  5. Take the Xterra out on the road to see how the engine sounds. If you notice a knocking sound, the new sensor may be faulty or you may have another problem that requires a mechanic. Take the car to the Nissan dealership and inform the parts clerk that the new sensor may not be the problem so you can set up a time to service the Xterra.