How to Install a Nissan Xterra Front Plate Holder
Not all Nissan Xtrerra’s will come with a front plate holder because not all states require a front license plate. This project won't take much time at all and only require a few tools. A lot of people like to purchase custom plate holders.
Things You'll Need:
- Bucket
- Soap
- Water
- Towel
- Pen
- Tape Measure
- Level
- Drill
- Wrench
- Clean the front bumper of your Nissan Xterra. You should just need a small bucket with soap and water. Make sure you dry it thoroughly with a towel after you're done.
- Look at the bumper for two small indentations. Some Xterra's might have these spots that represent where the front plate will be mounted. You'll have to measure and mark two spots if you don't notice the indentations. Make sure you use a level and tape measure to ensure accuracy.
- Drill a pilot hole at the spots you marked. A pilot hole is drilled with a very small drill bit. This will make it easier to drill the final hole with a larger drill bit. The larger bit can easily slide along the bumper without a pilot hole. The size of the final drill bit will need to be the size of the bolts that come with the bracket.
- Attach the bracket to your bumper by inserting the bolts through the front of the bracket and into the hole. Attach the nut and washers to the back of the bolt with a small socket and wrench. Make sure it looks level. You'll need to drill another hole if it isn't level unless you don't mind a crooked looking license plate.