Previous Article

Skills Needed for Carpenter Jobs

Next Article

How to Install Wings on a 350Z

How to Change a 350Z Thermostat

A car's thermostat is one of the most important components to keeping the engine cool. It regulates the amount of coolant that the engine receives so that it can maintain a decent temperature. When the thermostat on a car begins to fail, keeping the engine from heating or cooling properly. Especially in higher performance cars, such as the 350Z, the thermostat is even more important.


 


  1. Park your Nissan 350Z on a level surface, such as a driveway. Turn the engine off and wait for it to cool. It is important that the engine have plenty of time to cool, which can take a few hours.

  2. Open the hood of the car and check to see if the radiator cap is cool enough to remove. If it is cool enough, then remove the cap carefully.

  3. Place the catch can for the coolant under the radiator on the driver side. Next, unplug the wire to the temperature sensor that is located at the bottom of the radiator.

  4. Remove the coolant sensor using a wrench. It is important that you remove the sensor carefully because you do not want to damage any of the electrical connector tabs. Allow the coolant to drain into the catch can, then place the sensor back into place. Plug the sensor wire back in once the sensor is in place at the bottom of the radiator.

  5. Locate the thermostat housing near the radiator hose. Remove the housing while making note of how it was positioned. Once you have cleaned the housing, place the new thermostat in the same way as the old one.

  6. Reconnect any cables or hoses that you had unplugged and replace the engine coolant that had previously been drained.

  7. Check the coolant level as you drive the car around because you may need to add more as air slowly works its way out of the system.