How to Install Wings on a 350Z
There are two methods of mounting the wings to your 350Z and for the more timid among you this is the less invasive of the two. The first method is to bolt it to the trunk lid. This method uses no drilling or bolting and will not offer the opportunity to leak as drilling would.
Items Needed:
- Masking tape for automobiles
- Wax remover
- Soft polishing towel
- 3M tape – double sided
- 3M adhesive spray
- Wing
- Make certain that the trunk area where the wing is being placed is thoroughly clean. Use the wax remover and the polishing towel to do this. It must be free of wax and dirt and grease.
- Try positioning the wing on the trunk lid in a dry run to see exactly where you are placing it. Once you have it in position place your automotive masking tape around the edges of the mounts to mark it. Remove the wing and set it aside.
- Take the 3M adhesive spray and coat the inside of the areas where you just put the double-sided tape. Any part of the wing that comes in contact with the trunk lid may be sprayed as well. That will hold it down more firmly.
- Use the 3M double-sided tapes now and place it inside the areas you just sprayed. Keep the tape about a ¼ inch inside the area marked so you won’t be able to see it when done.
- Put the wing onto the tape at this point. Take your time and make certain it is aligned properly. When attached apply pressure to make sure it is sticking to the tape well.