Previous Article

How to Change the Oil in a Nissan Sentra

Next Article

How to Install a Nissan Sentra Engine Mount

How to Change the Thermostat in a Nissan Sentra

The Nissan Sentra is a favorite among used-car buyers. Equipped with a fully independent suspension system and great trim options the Nissan Sentra is a vehicle commonly seen out on the open road. For owners of the Sentra, one the easiest do-it-yourself repair jobs is the installation of a thermostat.

What You'll Need:



  • Container to dispose of radiator coolant

  • Genuine RTV Silicone Sealant

  • Mild detergent

  • Coolant

  • Manufacturer vehicle manual



  1. Before you begin, briefly review the manufacturer vehicle manual to familiarize yourself with the major components of the vehicle. This is the booklet that came along with the purchase of the vehicle.

  2. Locate the hood release latch, engage it and open the hood.

  3. Drain all of the coolant from inside the radiator into an acceptable container. Remove the negative battery cable from inside the terminal.

  4. Unplug the radiator lower hose from the inlet side of the engine. Remove the engine coolant inlet and the thermostat.

  5. Put in the new thermostat allowing the entire circumference of the flange to rest securely within the inside of the rubber ring. Ensure that the jiggle valve is pointed upward with a slight deviation of position of about negative/positive 10 degrees. 

  6. Use a genuine RTV Silicone Sealant to install the temperature sensor for the engine coolant. Then apply a mild detergent onto the O-Ring when you place the heater pipe inside the housing area.

  7. Fill in the cooling system with the suggested type and amount of coolant.

  8. Reconnect the battery.

  9. Turn your vehicle on and allow it to run for several minutes. Check underneath the vehicle for any coolant leaks.