How to Install a Nissan Sentra Engine Mount
Installing a Nissan Sentra engine mount can be a labor of love, the engine mount is designed to anchor the engine to the car while offering some shock absorption. Engine mounts take a lot of engine strain over the life of the car, so learning how to install the mount is very important.
Replacing any car parts can save money and labor fees. Following instructions to the letter, will ensure a safe and complete engine mount.
- Put your safety glasses on and slide under the car.
- Use the flashlight to locate the engine mount and bolts holding the mount in place.
- Remove the bolt holding the engine mount to the chassis using your socket set. This may require some serious elbow grease, so be careful not to overdo it and smash your knuckles when the bolt finally comes free and turns.
- Climb out and slide the jack under, placing the jack head near the engine mount, but not on it.
- Jack the engine up far enough for the engine mount to lift off the chassis where you removed the bolt in step three.
- Climb back under and remove the bolt holding the engine mount to the engine. Put the old mount to the side, position the new mount and then bolt it tothe engine in reverse of how you removed the old mount.
- Climb back out and lower the engine. Pull the jack out and climb back under the Sentra.
- Install the bolt into the engine mount from the chassis and tighten it down in reverse of how it was removed.
Remember to follow these directions, while using the right equipment and your project will come out fine.