Previous Article

How to Install a Nissan Murano Front Grille Emblem

Next Article

How to Replace Nissan Murano Brake Pads

How to Program a Nissan Murano Key Fob

The Nissan Mureno is Nissan's first mid-range crossover SUV.  It was released on the market in 2003.  This model has a keyless entry that allows you control access the vehicle remotely.  The key fob allows you to lock and unlock the doors and trunk.


  1. Open the driver side door.

  2. Close and press the lock/unlock control panel on the driver side door.

  3. Insert the key into the ignition quickly six times within ten seconds.

  4. Notice the emergency lights flash once the computer is in program mode.

  5. Remove key from ignition.

  6. Reinsert key and turn upside down to "Acc" position.

  7. Press "lock" on the key fob to see if programming has been accepted.

  8. Hazard lights will flash if programming was successful.

  9. Remove key from ignition.

  10. Press "unlock" on key fob to see if the unit is working properly.


To program other key fobs for your Nissan Murano.



  • Programming will cancel out any prior programming on key fob unless otherwise pre-defined.

  • If key fob is not compatible with Nissan keyless programming protocols, contact Nissan regarding the matter.

  • Follow steps one through ten to program other key fobs.

  • Place key fobs that have been programmed away from the inside of car while the other fobs are being activated to prevent problems with the programmed key fobs.

  • Be sure to keep key fobs dry and in a safe place when not in use.

  • Refer to your operational manual or call Nissan for further instructions if you have any questions or the steps are not working for your remote unit.